Table of Contents

Previous

Next

PROBES & SENSORS page 04.01

Working with the design of new sensors, we recommend to store each sensor with a name that relate to the used probe. When all sensors are created, store them under a name - click "Save".

An existing sensor can be changed - click on "Properties". After editing click on "Save".

Which probe is active: The name is shown.

Serial number on probes: AQUA-16 is readable at the outside cylinder. 120 relate to serial No.

Should you by accident make a profile with a wrong probe (wrong calibration figures), do the following:

1. Click Files & Open 2) Call in the file 3) Click Probe & Editing

All calibration figures have to be changed, and only one file at the time.

See section 3 regarding change of calibration figures.